EXTRON MTP 15 HD A

MTP 15HD A Series 

 

Video

   Gain 

Unity

   Number/signal type 

1 set of proprietary analog signals

   Connectors 

 

      MTP R 15HD RSA D 

1 female RJ-45 on a pigtail

      All other models 

1 female RJ-45

 

Video input and loop through  — transmitters

   Number/signal type 

 

      MTP T 15HD A 

1 analog RGBHV, RGBS, RGsB, RsGsBs, component video, S-video, or composite video
1 buffered RGBHV, RGBS, RGsB, RsGsBs local monitor loop through (includes ID bits)

      MTP T 15HD A AAP, MTP T 15HD A D, MTP T 15HD A WM 

1 analog RGBHV, RGBS, RGsB, RsGsBs, component video, S-video, or composite video

   Connectors 

 

      MTP T 15HD A 

2 female 15-pin HD

      All other transmitters 

1 female 15-pin HD

   Nominal level 

1 Vp-p for Y of component video and S-video, and for composite video
0.7 Vp-p for RGB and for R-Y and B-Y of component video
0.3 Vp-p for C of S-video

   Minimum/maximum levels 

0.3 V to 1.45 Vp-p

   Impedance 

75 ohms

   Horizontal frequency 

15 kHz to 130 kHz

   Vertical frequency 

30 Hz to 150 Hz

   Return loss 

<-30 dB @ 5 MHz

   DC offset (max. allowable) 

250 mV

 

Video output — receivers  (MTP RL 15HD A, MTP RL 15HD A SEQ, MTP R 15HD RSA D)

   Number/signal type 

 

      MTP R 15HD RSA D 

1 analog VGA-UXGA RGBHV, RGBS, RGsB, RsGsBs, HD component video, component video, S-video, or composite video

      All other receivers 

1 set of proprietary analog signals
1 analog RGBHV, RGBS, RGsB, RsGsBs, component video, S-video, or composite video

   Connectors 

 

      MTP R 15HD RSA D 

1 female 15-pin HD

      All other receivers 

1 female RJ-45
1 female 15-pin HD

   Nominal level 

1 Vp-p for Y of component video and S-video, and for composite video
0.7 Vp-p for RGB and for R-Y and B-Y of component video
0.3 Vp-p for C of S-video

   Minimum/maximum levels 

0.3 V to 1.45 Vp-p

   Impedance 

75 ohms

   Return loss 

<-30 dB @ 5 MHz

   DC offset 

 

      MTP R 15HD RSA D 

<±20 mV with input at 0 offset

      All other receivers 

<±35 mV with input at 0 offset

   Skew compensation 

62 ns

   Maximum resolution 

Up to 1920x1200 or 2048x1080 or 1080p at 300'
Up to 1024x768 at 600'

       NOTE    

See the user guide for the maximum distances recommended for specific resolutions.

 

Sync

   Input type (transmitters) 

RGBHV, RGBS, RGsB, RsGsBs

   Output type (receivers) 

RGBHV, RGBS, RGsB, RsGsBs

   Standards 

NTSC 3.58, NTSC 4.43, PAL, SECAM

   Input level (transmitter) 

3.5 V to 5.5 Vp-p, unterminated

   Output level (receivers) 

4.0 V to 5.0 Vp-p, unterminated

   Input impedance (transmitter) 

573 ohms ±5%

   Output impedance (receivers) 

110 ohms

   Max. input voltage (transmitter) 

5.5 V p-p

   Polarity 

 

      Transmitter 

Positive or negative (follows input polarity)

      Receivers 

Positive or negative (switch-selectable)

 

Audio   — all models

   Number/signal type 

1 set of proprietary analog signals

   Connectors 

1 female RJ-45

   Gain 

Unbalanced output: 0 dB; balanced output: +6 dB

   Frequency response 

20 Hz to 20 kHz, ±1 dB

   THD + Noise 

0.15% @ 1 kHz, 0.3% @ 20 kHz at nominal level

   S/N 

>70 dB at maximum output (unweighted)

   Stereo channel separation 

>60 dB @ 1 kHz

   CMRR 

>43 dB @ 20 Hz to 20 kHz

 

Audio input  — transmitters

   Number/signal type 

1 stereo, unbalanced

   Connectors 

(1) 3.5 mm mini stereo jack

   Impedance 

>10k ohms, unbalanced

   Nominal level 

+4 dBu (1.23 Vrms), -10 dBV (316 mVrms)

   Maximum level 

+18 dBu, (unbalanced) at 1%THD+N

    NOTE    

0 dBu = 0.775 Vrms, 0 dBV = 1 Vrms, 0 dBV ≈ 2 dBu

 

Audio output  — MTP T 15HD A AAP, MTP T 15HD A D, MTP T 15HD A WM local stereo output

   Number/signal type 

1 stereo, balanced/unbalanced

   Connectors 

(1) 3.5 mm direct insertion captive screw connector, 5 pole

   Impedance 

50 ohms unbalanced, 100 ohms balanced

   Gain error 

±1 dB channel to channel

   Maximum level (Hi-Z) 

>+23 dBu, balanced or unbalanced at 1% THD+N

   Maximum level (600 ohm) 

>+17 dBm, balanced or unbalanced at 1% THD+N

 

Audio output  — receivers

   Number/signal type 

 

      MTP R 15HD RSA D 

1 mono, balanced/unbalanced

      All other receivers 

2 mono, balanced/unbalanced

   Connectors 

 

      MTP R 15HD RSA D 

(1) 3.5 mm captive screw connector, 5 pole (uses 3 poles)

      All other receivers 

(1) 3.5 mm captive screw connector, 5 pole

   Impedance 

50 ohms unbalanced, 100 ohms balanced

   Gain error 

±1 dB channel to channel

   Nominal level 

+4 dBu (1.23 Vrms), -10 dBV (316 mVrms)

   Maximum level 

 

      MTP R 15HD RSA D 

14 dBm, unbalanced at 1% THD+N

      All other receivers 

+18 dBu, unbalanced at 1% THD+N

 

Control/remote — external device (pass-through, unidirectional or bidirectional)  — MTP R 15HD RSA D only

   Serial control port input/output 

1 set of proprietary signals on a female RJ-45 jack

   Serial control port output/input 

RS-232 via 3 poles of a 3.5 mm captive screw connector, 5 pole

   Baud rates 

Up to 38400 bps at up to 1000' (304.8 m) (Higher data rates and distances are possible. Performance varies based on baud rate and cable length.)

   Protocol 

Data bits = 5 - 8
Stop bits = 1 or 2
Parity = odd, even, none
Flow control = XON, XOFF, none

    NOTE    

Protocol is mirrored between the transmitter and the receiver.

   Serial control pin configuration 

Captive screw connector: 1 = Tx, 2 = Rx, 3 = GND

 

General

   Recommended cable type 

CAT 5/5e/6 (shielded or unshielded)

   Power supply 

External
Input: 100-240 VAC, 50-60 Hz
Output: 12 VDC, 1 A, 12 watts

   Power input requirements 

12 VDC, 0.5 A

   Temperature/humidity 

Storage: -40 to +158 °F (-40 to +70 °C) / 10% to 90%, noncondensing
Operating: +32 to +122 °F (0 to +50 °C) / 10% to 90%, noncondensing

   Cooling 

Convection, no vents

   Mounting 

 

      Rack mount 

 

         MTP T 15HD A, MTP RL 15HD A, MTP RL 15HD A SEQ 

Yes, with optional rack shelf

      Furniture or wall mount 

 

         MTP T 15HD A, MTP RL 15HD A, MTP RL 15HD A SEQ 

Yes, with optional under-desk mounting kit

         MTP T 15HD A AAP 

Yes, with optional AAP mounting faceplates that have double space high AAP opening

         MTP T 15HD A D, MTP R 15HD RSA D 

Yes, in a Decora®-style opening with a standard electrical wall box or Decora size mud ring

         MTP T 15HD A WM 

Yes, in a 1-gang opening

      Pole mount 

 

         MTP T 15HD A, MTP RL 15HD A, MTP RL 15HD A SEQ 

Yes, with optional pole mounting kit

   Enclosure type 

Metal

   Enclosure dimensions 

 

      MTP T 15HD A, MTP RL 15HD A, MTP RL 15HD A SEQ 

1.7" H x 4.3" W x 3.0" D (1U high, quarter rack wide)
4.3 cm H x 10.9 cm W x 7.6 cm D
(Depth excludes connectors.)

      Faceplates 

 

         MTP T 15HD A AAP 

1.4" H x 3.5" W x 0.1" D (3.6 cm H x 8.9 cm W x 0.3 cm D)
(double space high AAP plate)

         MTP T 15HD A D, MTP R 15HD RSA D 

2.6" H* x 1.3" W x 0.1" D (6.6 cm H* x 3.3 cm W x 0.3 cm D)
(Fits the opening in a 1 gang, 4.4" H x 2.7" W Decora-style wallplate. Depth excludes connectors.)
*Overall height is 4.1" (10.4 cm) including mounting tabs.

         MTP T 15HD A WM 

4.5" H x 2.8" W x 0.1" D (11.4 cm H x 7.1 cm W x 0.3 cm D) (1 gang)

      Device 

 

         MTP R 15HD RSA D 

2.75" H x 1.65" W x 1.3" D
(7.0 cm H x 4.2 cm W x 3.3 cm D)
(Depth excludes connectors.)

         Other AAP, D, and WM models 

2.7" H x 1.4" W x 1.4" D (6.9 cm H x 3.6 cm W x 3.6 cm D)
(Depth excludes connectors.)

   Product weight 

0.4 lbs (0.2 kg)

   Shipping weight 

2 lbs (1 kg)

   Vibration 

ISTA 1A in carton (International Safe Transit Association)

   Regulatory compliance 

 

      Safety 

CE, c-UL, UL

      EMI/EMC 

CE, C-tick, FCC Class A, ICES, VCCI

   MTBF 

30,000 hours

   Warranty 

3 years parts and labor

    NOTE    

All nominal levels are at ±10%.

    NOTE    

Specifications are subject to change without notice.

Quý khách có thể gửi ý kiến mà không cần đăng nhập tài khoản khách hàng.
Họ tên
Đánh giá
Ý kiến
Sản phẩm cùng nhóm
Liên hệ 090.536.6656
EXTRON VSC 500
• Biến đổi tín hiệu RGBHV ra Video Composite
• Thay đổi được khung hình ảnh 
• Có chức năng Zoom và Presets

 

  • Bảo Hành: 3 tháng chính hãng